12V 60mm Fan – Reliable Cooling for Industrial & PC Applications
60x60x15mm and 60x60x25mm | Ball bearing | PWM optional | UL/CE certified. Factory direct from LINKWELL – the voltage standard for 3D printers, servers, and control panels.
50,000+ hours life
UL / CE / RoHS
OEM / ODM ready
The Most Common Voltage for 60mm Fans
12V DC is the standard across PC cooling, industrial controls, 3D printers, and servers. It strikes the right balance between power efficiency, component availability, and safety.
| Voltage | Typical Applications | Advantage | Disadvantage |
|---|---|---|---|
| 12V | PC, industrial control, servers, 3D printers | Most common, easy to replace, widely available | — |
| 24V | Telecom base stations, high-end industrial | Lower loss over long cables | Requires 24V power supply |
| 5V | USB devices, embedded systems | USB direct power | Lower airflow |
| 110/220V AC | Industrial cabinets, HVAC | No power converter needed | No speed control options |
Typical applications for 12V 60mm Fan
3D Printers
Hotend cooling, control box ventilation – 12V is standard on most Creality, Prusa, and Ender printers.
Industrial Control Panels
VFDs, PLCs, servo drives – 12V available from standard control power.
PC Cases & CPU Coolers
Small form factor builds, HTPC, 1U servers, and aftermarket CPU cooler replacements.
Fan
Model
Size
(mm)
Voltage
(VAC)
Power
(W)
Speed
(RPM)
Airflow
(CFM)
Fan
Model
Size
(mm)
Voltage
(VAC)
Power
(W)
Speed
(RPM)
Airflow
(CFM)
PWM speed control & tachometer feedback
PWM (Pulse Width Modulation)
4-wire interface. Adjust fan speed by sending a 25kHz duty cycle signal from your controller. Lower speed = less noise + longer life.
FG (Tachometer)
Real-time RPM feedback. Your system reads the pulse signal to verify the fan is working – critical for servers and medical devices.
| Connection | PWM | FG | Use Case |
|---|---|---|---|
| 2-pin | No | No | Simple on/off cooling |
| 3-pin | No | Yes | Speed monitoring only |
| 4-pin | Yes | Yes | Closed-loop control |
Tailor your 12V 60mm fan
Connector & Cable
JST, Molex, DuPont, custom pin assignment – any length.
Speed Tuning
Custom RPM – low noise or high airflow.
IP Protection
IP54, IP56, IP68 – conformal coating available.
Private Label
Custom logo on label, custom packaging, OBM service.
PWM/FG
Add 4-wire PWM and tachometer to any model.
Voltage Variants
5V, 12V, 24V – same 60mm frame.
100% Burn-In Tested
Every 12V 60mm fan runs 4–24 hours under rated voltage. Each unit tested for airflow, noise, current, and dielectric strength.
Performance Verification
Airflow tolerance ±5% · RPM tolerance ±10% · Noise tested in low-noise chamber.
Electrical Safety
500V AC withstand test for DC fans · 1500V AC for AC series.
Full Traceability
Unique lot number per fan – root-cause analysis if needed.
Certifications of Brushless DC Fans
