Blog

A 120 x 120 x 25 mm fan and a 120 x 120 x 38 mm fan fit the same panel opening, so the thicker version can look like an

In a multi-fan enclosure, one stopped fan is not always just “zero airflow.” Its opening can become a low-resistance leak. The remaining fans pressurize one side of the panel, and

An enclosure can have two fans running at full speed and still develop a hot spot. The fans may be moving plenty of air, but not enough of that air

The fan reaches its specified speed, the catalog curve looks adequate, and the enclosure still runs hot. This is a common point where a team suspects a bad fan. The

A fan that runs quietly on a vertical test bench may behave differently when installed flat in the roof of a cabinet. Gravity has not changed the airflow requirement, but

Two fans can carry the same model number, run from the same supply and still settle at slightly different speeds. That does not automatically mean one is defective. Rated speed

A fan is specified for an outdoor cabinet. The datasheet temperature range appears to cover the site, but the fan sometimes fails to start on winter mornings and becomes noisy

A two-wire fan is connected during a prototype build, but the red and black leads have been swapped. Nothing turns. After the wiring is corrected, the fan starts normally. Was

An electrical enclosure works comfortably during a factory test near sea level. The same design is installed at a mountain site, where the fan still spins at its expected RPM

A fan datasheet says 58 dB. Another says 52 dBA at one meter. The smaller number looks quieter, but those two specifications may not describe the same quantity or the

Two cooling fan quotations land on your desk. One lists an L10 life of 70,000 hours. The other lists an MTBF of 200,000 hours. The second number looks far better,

A controller shows a clean 50 percent PWM command, yet the fan runs at full speed, pulses, hums, refuses to start, or reports an unstable tachometer signal. The duty-cycle setting